OpenShell UKHASnet Arduino firmware v0.0.38+ 2016-09-22T19:52:31Z
Revision: f3d1bb2ea50f05c0aed5edc3802cb26144b13c0a+@default
Node: OSTEST
Free RAM: 1242
BMP280 ID: 0
DBG:rfm69_reset
DBG:rf69_init
DBG:rf69_set_mode
Setting 0x1 = 0x10
Setting 0x2 = 0x0
Setting 0x3 = 0x3E
Setting 0x4 = 0x80
Setting 0x5 = 0x0
Setting 0x6 = 0xC5
Setting 0x7 = 0xD9
Setting 0x8 = 0x60
Setting 0x9 = 0x12
Setting 0xB = 0x0
Setting 0x11 = 0x9F
Setting 0x12 = 0x3
Setting 0x13 = 0x1A
Setting 0x18 = 0x0
Setting 0x19 = 0x42
Setting 0x1E = 0xC
Setting 0x25 = 0x40
Setting 0x26 = 0x7
Setting 0x2E = 0x88
Setting 0x2F = 0x2D
Setting 0x30 = 0xAA
Setting 0x37 = 0x90
Setting 0x38 = 0x40
Setting 0x3C = 0x85
Setting 0x3D = 0x12
Setting 0x6F = 0x30
Radio started.
REG_01_OPMODE: 0x1E
REG_02_DATA_MODUL: 0x0
REG_03_BITRATE_MSB: 0x61
REG_04_BITRATE_LSB: 0x0
REG_05_FDEV_MSB: 0x0
REG_06_FDEV_LSB: 0xC5
REG_07_FRF_MSB: 0xE4
REG_08_FRF_MID: 0xC0
REG_09_FRF_LSB: 0x0
REG_0A_OSC1: 0x41
REG_0B_AFC_CTRL: 0x40
REG_0D_LISTEN1: 0x92
REG_0E_LISTEN2: 0xF5
REG_0F_LISTEN3: 0x20
REG_10_VERSION: 0x24
REG_11_PA_LEVEL: 0x9F
REG_12_PA_RAMP: 0x3
REG_13_OCP: 0x1A
REG_18_LNA: 0x8
REG_19_RX_BW: 0x42
REG_1A_AFC_BW: 0x8A
REG_1B_OOK_PEAK: 0x40
REG_1C_OOK_AVG: 0x80
REG_1D_OOF_FIX: 0x6
REG_1E_AFC_FEI: 0x1C
REG_1F_AFC_MSB: 0x0
REG_20_AFC_LSB: 0x0
REG_21_FEI_MSB: 0x0
REG_22_FEI_LSB: 0x0
REG_23_RSSI_CONFIG: 0x2
REG_24_RSSI_VALUE: 0xFF
REG_25_DIO_MAPPING1: 0x40
REG_26_DIO_MAPPING2: 0x7
REG_27_IRQ_FLAGS1: 0x0
REG_28_IRQ_FLAGS2: 0x0
REG_29_RSSI_THRESHOLD: 0x0
REG_2A_RX_TIMEOUT1: 0x0
REG_2B_RX_TIMEOUT2: 0x0
REG_2C_PREAMBLE_MSB: 0x0
REG_2D_PREAMBLE_LSB: 0x0
REG_2E_SYNC_CONFIG: 0x13
REG_2F_SYNCVALUE1: 0x0
REG_30_SYNCVALUE2: 0x0
REG_37_PACKET_CONFIG1: 0x10
REG_38_PAYLOAD_LENGTH: 0x0
REG_3B_AUTOMODES: 0x0
REG_3C_FIFO_THRESHOLD: 0x0
REG_3D_PACKET_CONFIG2: 0x0
REG_4E_TEMP1: 0x2
REG_4F_TEMP2: 0x0
REG_58_TEST_LNA: 0x0
REG_5A_TEST_PA1: 0x0
REG_5C_TEST_PA2: 0x0
REG_6F_TEST_DAGC: 0x0
REG_71_TEST_AFC: 0x0
DBG:rfm69_set_frequency
Setting frequency to: 869.5MHz = 0xD95FEF
Frequency was set to: 0.01MHz = 0xF0
DBG:sendOwn
Free RAM: 1244
DBG:getChipTemp
DBG:send
9aV3.21T20.24,0P81154.4H6Z0[OSTEST]
DBG:send_rfm69
DBG:rf69_send
DBG:rf69_set_mode


OpenShell UKHASnet Arduino firmware v0.0.38+ 2016-09-22T19:52:31Z
Revision: f3d1bb2ea50f05c0aed5edc3802cb26144b13c0a+@default